Paint Boats sale (Flexible)

BUY PAINT CANVAS AND PVC SHEETS

.

FLEXIBLE PAINT GLAZE BUY ALL AND CANVAS

.

IF YOU WANT TO KNOW MORE ABOUT ALL paint to paint and canvas, click here or comes into our blog.

.

NATURE AND COMPOSITION OF PAINTING CANVAS

Lonas painting is made of very fast drying thermoplastic acrylic resins.

.

CHARACTERISTICS OF PAINT FOR PVC blinds and covers

Lonas paint finishes provides high adhesion, extremely fast drying, very good flexibility and elasticity.

.

WHERE CAN I APPLY FOR PAINTING Boats sale?

Coating mainly used for coating of PVC.

It is a special acrylic enamel paint awnings PVC and other rubber surfaces, flexible plastics such as tires and tarps.

In addition, the paint for canvases can also be used to paint pools with removable canvases.

It has great adhesion to these materials and flexibility.

.

HOW TO USE FLEXIBLE TO PAINT ELESMALTE Boats sale?

First verify that a tarp or awning PVC The surface must be completely free of dirt and grease tratade. perfectly clean the surface with solvent or degreaser.

When applied be respected recommended to prevent drying problems thickness and risk of cracking, excess layer.

This requires dilute industrial fast drying solvent so that a liquid mixture is obtained and can be applied very thin layers in order to not exceed the limits of thickness of the layers and the paint can "cure" and hold While the resilient surface.

spray application is recommended if posible.Si could not be use a foam roller or very short hair.

Once the canvas is covered apply more paint is counterproductive and could be at risk of cracking excess layer.

1. - Clean the surface either by removing any remaining impurities and prevent good adhesion.
2. - Mix the contents of the pack stirring thoroughly.
3. - The application can be done with a roller, airbrush or airless system.
4. - The first coat is applied diluted by 10-20% with our Synthetic Industrial Solvent; for resale can be diluted 5-10%

PRECAUTIONS WHEN USING ACRYLIC PAINT TO CANVAS

Make a good ventilation in the room and have a good extraction system.
Use activated carbon mask, goggles and gloves during application.
For more information see the data sheet for the product safety.

TECHNICAL DATA

• Finish: Satin
• Density: 1.05-1.15 g / cm³ (slight variations depending on the color)
• Viscosity: 150-200 "Ford Cup # 4
• VOC: 535 g / l
• Solids by weight: 50-55%
• Solids: 42-48%
• Theoretical coverage: 11-14 m² / liter
• Repainting: 1 hour
• Film thickness: 35-40 microns
• Thinner: Synthetic Industrial Solvent
• Colours: RAL

.

PRESENTATION OF PAINT for blinds and covers

It comes in packs of 4 liters and 20 liters.

. 

 We guarantee the quality of our products in accordance with our general conditions of sale and supply.
Our technical advice for use, expressed verbally, in writing or through tests, is offered in accordance with our current knowledge and experience. They constitute simple indications, which do not compromise our responsibility, nor do they exempt you from the need to verify for yourself that the products supplied by us correspond to the procedures and objectives sought by you, carrying out your own controls and tests. The application and use of the products are beyond our control, and consequently, depend exclusively on your personal responsibility, and we cannot be held responsible for results other than those reflected here. Our safety recommendations do not prevent you from determining your own measures, adapted to the conditions of your facilities. We reserve the right to vary the data contained herein, without prior notice, according to technological evolution thereof.