Barniz POLIURETANO AL AGUA (2C)
Barniz POLIURETANO AL AGUA (2C)
Barniz POLIURETANO AL AGUA (2C)
Barniz POLIURETANO AL AGUA (2C)

Water-based polyurethane varnish (SHINE 2C)

€176.97
Tax included

MICROCEMENTO SEALER VARNISH AND BASE METAL FLOORS IN BAGUA

WATER aliphatic polyurethane TWO COMPONENT BRIGHT GREEN

Suitable for vertical and horizontal protect decorative pavements located in interor and abroad.

High wear resistance, UV rays, and cleaning detergents.

High mechanical and chemical resistance.

very low odor

KILOS
  • 5,05 KG ( JUEGO 5 + 0.5 )
Color
  • transparent
FINISH
  • Gloss


<b>10</b> By purchasing this product, you will accumulate 20 points with our loyalty program. You can convert 20 points in your account into a coupon for a future purchase.

 

IF YOU HAVE QUESTIONS ABOUT WHICH VARNISH YOU MUST APPLY, CLICK HERE, WE INFORM YOU, OF THE MOST SUITABLE VARNISH FOR EACH SITUATION.
....

IF YOU WANT TO READ MORE INFORMATION ABOUT THE 3D DECORATIVE FLOORS OR FLOORS EFFECT MIRROR CLICK HERE!

....

IF YOU WANT TO KNOW MORE ABOUT THE PAINTINGS OF TWO COMPONENTS, WHAT IS IT? AND HOW TO USE IT? CLICK HERE TO READ OUR BLOG ARTICLE

BUY VARNISH two component polyurethane gloss finish WATER

.

ORDER TO PROTECT FLOORS BARNIZ MICROCEMENTO O METALLIC FLOORS

.

NATURE OF WATER POLYURETHANE VARNISH TWO COMPONENTS


It is a colorless sealant formulated with aliphatic polyurethane coating 2-component water based.

.

POLYURETHANE WATER FEATURES TWO COMPONENTS


- High wear resistance.
- Suitable for use indoors or outdoors.
- Resistant to UV rays.
- Resistant to common cleaning chemicals.
- Based on water.
- Very low odor.

.


WHERE CAN I USE THE WATER POLYURETHANE TWO COMPONENT?


- Sealing of cementitious decorative coatings both vertical and
horizontal located indoors or outdoors.


- Suitable sealant for flooring and metal flooring microcemento

.

HOW SHOULD I USE THE WATER POLYURETHANE BICOMPONENTE?

- Before applying the product to verify that the surface is dry and clean (free of dirt, grease, oil ...).


- Avoid condensation on the surface to be protected as it can cause bubbles in the product first hand.


- The contents of the two containers were previously stirring thoroughly homogenized. Subsequently the two components are mixed with a mechanical stirrer at low speed to avoid introducing air into the mixture for 2 minutes.

Keep in mind that the life of the mixture at 20 degrees is 2 hours, after which time the material should not be applied although visually seems to be in good condition.

- The mixing ratios between the two components are these:



Brightness .............. 5 / 0.5 kg or what is the same 10/1 by weight.


- It shall apply with short hair roller or low pressure spray in very thin layers to achieve total coverage of the surface. Stretch the material enough to not cause waterlogging and excessive accumulation of material. Try that overlap each other cloths on are still fresh, so marks are avoided.


- For the application of the second hand allow sufficient time for the surface drying occurs and lost tackiness observed no evidence of moisture time. At least 4 hours.


- A minimum two coat application is recommended. In the case of application to microcemento most often it is sufficient. If necessary by excessive porosity of the substrate apply a third coat.


- During the drying of the product must have sufficient ventilation to remove excess moisture.


- Do not use cleaning products during the first week of pavement usage (including water). After this time to clean the surface using water with neutral detergent.


- Cleaning of the tools used will be made with water before material dries.

.

PRECAUTIONS WHEN USING WATER POLYURETHANE TWO COMPONENTS


Wear safety goggles and protective gloves during application.


For more information see the data sheet for the product safety.

.

PACKAGING OF WATER BICOMPONENTE POLIURETANO


It comes in gloss finish packaging:


Component A: 5 kilos Component B: 0.5 kilos

Technical advice for use and use of our products are given according to our best knowledge and information, the result of tests conducted in our laboratories and our experience gathered over the years customer service.


ANGAR paintings, SC will not be responsible for problems caused by misapplication or misuse of our products.

.For The price to buy varnish two component polyurethane water to portege microcemento floors and metal flooring can consult the top of this page.

.

.

Theoretical performance
0.100 kgs x square meter X hand
Repainted
At least 4 hours
FINISH
Brightness / Mate
Useful of Application
Short hair roller / Airless
Cleanliness Tool
Water
Color
Transparent or colorless
Time of dried to a temperature of 25 ºC and a relative dampness of 50 %
24 hours
Temperature of Application
Do not apply below 10 ° centrigrade
Proportion of the mixture
10: 1 by weight for brightness / 5: 1 by weight for mate
Useful life of the mixture
at 20 degrees Celsius: 2 hours
Density
1.02 +- 0.05 kgs/dm3
Humedad del soporte
Inferior al 10 %
B15 Brillo
500 Items

You might also like

Customers who bought this product also bought:

Reviews Reviews (0)

Based on 0 reviews - 0 1 2 3 4 0/5
Pinterest

Portes Gratis Angar para pedido + 75 €