Plastic transparent paint (matte)
PLASTIC PAINT FOR TRANSPARENT WALLS (MATE)
Plastic paint of very high quality, transparent or colorless finish especially recommended for high decoration.
Varnish for walls painted with latex paint, matte finish.
Transparent plastic paint to protect and decorate walls.
For walls indoors and outdoors.
BUY PAINTING WALL IN CLEAR PLASTIC OR PLASTIC CLEAR OR BUY PAINT WALL MATE.
COMPOSITION OF PAINT MATE FOR PLASTIC DECORATIVE PAINTING WALLS OR CLEAR CLEAR PLASTIC OR WALL AND CEILING
Very high quality plastic paint formulated emulsinados based copolymers and a selection of loads as well as a fine particle dispersion, which provide good conditions of weather resistance and especially recommended for finishing high interior decoration.
Additives formulated with fungicides and bactericides envitando the creation and spread of microorganisms, has character ANTIMOHO.
More than 40,000 double strokes washability according to DIN 53778. waterproof.
FIELDS OF APPLICATION OF PAINT CLEAR PLASTIC OR CLEAR
Both indoors and outdoors
For the protection and decoration of surfaces of plaster, concrete, plasterboard panels, precast concrete, masonry in general; horizontal and vertical surfaces.
For decoration and Protective walls painted with plastic paint.
For decorative effects on the walls.
PROTECT transparent graffiti, paintings and trompe atmospheric aggressions plastic paint.
PROPERTIES OF PLASTIC TRANSPARENT PAINT OR CLEAR
Waterproof A waterside
High efficacy against molds
Excellent elasticity and flexibility
DIRECTIONS CLEAR PLASTIC PAINT OR CLEAR
If you want to give a first hand to use as a primer, dilute the paint with approx. 20% water. Give one or two hands to homogenize desired texture and opacity. Masonry surfaces must be dry in order to allow moisture levels and alkalinity to decrease as possible.
On concrete or new cements will have to wait for its full setting (30 days approx.)
If the paint surface is in good condition, remove dust and apply one or two coats of latex paint.
If the old surface is in poor condition should be removed loose and friable surfaces, and proceed as in a new surface.
If the old paint is the glue, tempera or lime must be removed or primed with a fixative background.
Technical advice for the use and application of our products are given with best knowledge and information, the result of tests conducted in our laboratories and our experience gained over the years customer service.
ANGAR paintings, SC will not be responsible for problems caused by incorrect application of the products.
If you want to know the CLEAR PLASTIC PAINT OR CLEAR PRICE OR THE PRICE OF PLASTIC PAINT WALL AND CEILING, YOU CAN SEE, at the start of this page ..
- Theoretical performance
- Between 5 and 8 square meters X Kilo X I Run (Depending on the support, if it is new or already it is painted)
- 2 hours
- Useful of Application
- BRUSH / ROLLER / AIRLESS
- Cleanliness Tool
- Dissolution of the first hand
- Between 10 % and 20 %
- Dissolution in the second hand
- Between 0 % and 10 %
- Transparent or colorless
- Higher than 40,000 double strokes according DIN 53778 STANDARD
- 0.75 LITROS / 4 LITROS / 15 LITROS
- Time of dried to a temperature of 25 ºC and a relative dampness of 50 %
- To the tact 30 minutes