Plastic paint for interior walls and ceilings and exterior facades in Luminous White
Buy plastic paint in Luminous White, with great professional quality for high decoration, with a silky, smooth, matte and soft finish, maximum washability, excellent coverage and performance. All colors between mixable and suitable for lowering them with white
. ANTI MOLD character.
Monolayer plastic paint for walls and facades of color for interior and exterior, Premium quality
Buy plastic paint in color, with high professional quality for high decoration, with a silky, smooth, matte and soft finish, maximum washability, excellent coverage and performance. Anti mold.
BUY COLOR PLASTIC PAINT FOR INTERIOR AND EXTERIOR WALLS. Single layer
NATURE OF PAINTING FOR INTERIOR AND EXTERIOR
Exterior and interior matte plastic paint based on acrylic styrene emulsion. Washability greater than 20,000 double passes according to DIN 53778
TECHNICAL DATA OF PLASTIC PAINT FOR WALLS AND FACADES
Matte finish Theoretical performance: 5-8 m2 / layer Repainting: 2 hours Dry to touch: 30´ Application tools: Brush, roller or air-less Useful cleaning: Water Application temperature between 5 and 35ºC 1st coat dilution: 10-20% water 2nd coat dilution: 0-10% water
CHARACTERISTICS OF PLASTIC PAINT FOR INTERIOR AND EXTERIOR
Matte plastic paint to obtain highly decorative finishes, great quality for high decoration, with a silky finish, smooth matte and soft, maximum washability, as well as excellent coverage and performance. The shades are intermixable with each other, and can be lowered with white. Formulated with fungicidal and bactericidal additives avoiding the creation and spread of mycoorganisms, it is ANTI-MOLD.
FIELDS OF APPLICATION OF WATER-BASED PLASTIC PAINT
For the protection and decoration of surfaces of plaster, cement, plasterboard panels, precast concrete, masonry in general; in horizontal and vertical surfaces.
HOW TO USE THE PAINTING FOR WALLS AND FACADES
NEW SURFACES If you want to give a first coat to use as a primer, dilute the paint with approx. 20% water. Give one or two coats to homogenize the desired texture and coverage. Masonry surfaces must be well dry in order to allow humidity and alkalinity levels to decrease as much as possible. On concrete or new cements it will be necessary to wait for its total setting (30 days approx)
PAINTED SURFACES If the surface to be painted is in good condition, remove dust and apply one or two coats of paint. If the old surface is in poor condition, loose and poorly adhered surfaces should be removed and proceed as on a new surface. If the first paint is glue, temper, or lime, it must be removed or primed with a fixing primer.
The technical advice for the use and use of our products is given according to our best knowledge and information, the result of tests carried out in our laboratories and our experience gathered over the years at the customer's service. Pinturas ANGAR, S.C. will not be responsible for the problems caused by an incorrect application of the products
BUY CHEAP INTERIOR AND EXTERIOR PLASTIC PAINT AND OF EXCELLENT QUALITY. WE ARE MANUFACTURERS OF PAINT. PROFESSIONAL QUALITY AT FACTORY PRICES
Between 5 and 8 square meters X Kilo X I Run (Depending on the support, if it is new or already it is painted)
Useful of Application
BRUSH / ROLLER / AIRLESS
Dissolution of the first hand
Between 10 % and 20 %
Dissolution in the second hand
Between 0 % and 10 %
Higher than 20,000 double strokes according DIN 53778 STANDARD
1 KGS / 5 KGS / 23.5 KGS
Time of dried to a temperature of 25 ºC and a relative dampness of 50 %